bryan314
-
Posts
706 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Everything posted by bryan314
-
I believe you just use the ASCII equivalent number 35. Bryan Originally posted: http://www.eMastercam.com/ubb/Forum1/HTML/000615.html
-
I believe in the transition from 8.0 to 8.1 the ability to set these options in the defaults.df8 file (accessible through, screen - configure - nc setting - op defaults button) were disabled. The only way I found around this is to keep a copy of 8.0 on the system and set my 8.1 defaults with 8.0. Either by copying the file between aps or using 8.0 to access 8.1's defaults. Afterward DON'T look at the df8 file with 8.1 because it'll disable these options again. Bryan
-
I don't know if this works in m7 but in mastercam 8: 1) Have the hardcopy button on your toolbar. Or set a hot key. 2) From the operations manager turn on the operations you want to print. Pressing the T-Key will toggle them on and off. 3) Escape out of the Ops manager but stay in the toolpath section. Your paths should still be visiable. 4) press hardcopy button and print. Bryan
-
I've been working my way through the chook developers guide and doing ok. I've been able to figure out basic thing like menus, lines, arc and stuff. But I'm having the hardest time figuring out how to create someting like a note. Does anybody have an example piece of code showing how to create a note? Any help would be appreciated.
