Does anyone know if there is a way to prevent when editing a note or dimension to keep if from changing the configuration for new notes or dimensions?

Going from X9 to 2019 seeing issue with WCS D+ Z+ plane selection appears not to be working. In V9 when selected the screen indictor would switch to D/Z and when analyzing a feature it would give the results in diametrical. In 2019 when clicked on nothing appears to happen. Tested in 2018 as well with same results. Is there now a step I am missing? Thanks

Thanks #Rekd

Is there a way to define radial clearance on a lathe tool. IE face groove tool define the radial configuration of the insert blade to verify the tool can enter the face groove without interfering

Thanks David, your help help on this is greatly appreciated. I often import tools using the tool manufacturers cad models so that I can guarantee to a higher level of confidence that there will not be clearance issues when working with parts that have confined areas instead of using the standard tools that are in the Mastercam library . Your help will help making sure the tool is set up properly. Thanks again.

Thanks David, will check your file. Can you tell me what you did for future reference. Thanks again

The file was for uploading as requested the tool paths where not saved when. It was uploaded

Could not find a tool in the library that met the actual tool configuration, the part shown is not the actual part

File attached. Tool geometry is on level 2. Part configuration created to test the custom tool that is needed to verify tool clearance when working in actual part. Any help would be appreciated. Thank GROOVE TOOL TEST.MCX

Need help, created custom groove tool. When using it does not generate tool path using both sides of insert it treats it as a single point insert.