Thanks,I will give it a shot...

Hi, did you ever figure out this issue, I am having the same error message. No one seems to know anything about this ....

When you say repair install, do you mean reinstalling mastercam.

No luck here. The same error message...

Help... When I try posting out Gcode using Mastercam Editor, I receive a error that ActiveX component can't create object. I can use PFE and it works fine. Thanks in advance.

Control Definitions needed to be set. All is well Thanks guys!!!

Gcode is very long and value's that are in the parameter for peck drill are not controlling the amount of pecks that are desired. The output that is generated has very short pecks, from feed move to feed move it is only traveling a depth of .001 and then retracts. Two holes are generating a huge program where it should only be 10 lines.

Peck cycle's, in V9 had it working great.

After updating too X my once working post for a Makino mill no longer is working. Trying to fix but I can't get fastmode for debug to work, any info on this topic

Thanks Guys, I think turning off the canned pecking in the post is good for me!

Would like to be able to change Peck Depths in Fanuc pecking cycle. Current method allows only one depth, 1st peck is the same as the last peck which in my case is not the best method for deep holes.

Thank you!!

Help! is there anyway to set Boundry stock to a profile rather than a square block, this is a request from the shop floor!