Do you think think it ever will ? I use the mill one all the time and it works great. thank you joel

Can you use this in lathe? I am having troubles getting it to work. joel

Hello everyone. I need to cut a glass cover slip 2mm in dia and .17mm thick with a .02mm rad on one edge. I need help with what kind of cutter to use, that has vary tight tollerances? Thank you for any help. Joel

I have cut a couple ellipsoids using formulas. The f-plot chook works great. I usally use 3d-scalop or project blend. The only thing I do not know is how tight to make the grid for the points used to create the surface. Do the number of points afect the accuracy of the surface? joel

I use the stuff all the time, with vary good luck. The thickess is vary consistent, the stuff I have is .0045. You should becareful about cutting into the tape stay .005 off the tape. I use acetone to clean the parts It dosen't leave residue. Coolant and heat will affect the tape so use air to clear the chips. Mitee-bite makes some that is heat active. might be better for clearing the chips and coolant doesn't affect it. I have not tried it yet so don't know how well it works. hope this helps.

Could not find a centre drill small enough so I didn't use one. Finished the job last night everything worked out great. thank you for all your help. Joel

Thank you again for all the help I will let you know how it goes.

Hello everyone.I have to drill a .15mm hole 5mm deep in 304ss. I only have one shot to do it. Max rpm is 8000 what do you think I should use for chip load and peck depth? The drill is carbide. I have not heard back form the manufacture and, I have to do it today. thank you for any help. Joel

Sorry it is spherical. made from 2" bar stock.

Hello everyone. I have to make a tear drop out of 304 ss I was hoping someone could help me with Ideas for fixturing? I will be using F-plot to create the surface how tight should I make the grid? Do the node points afect the accurase of the surface? thank you for any help

still here joel

I had a gear that ran for five days Straight. 13' in dia. joel

Thank you for all the help. Went with .0007 doc 1. ipm 8000 rpm. Worked great once again thank you for your help. Joel

I think I may have been typing when your post came up I didn't see it till after I sent mine. I do not know what to do? I will think about it over lunch.I will let you know what I come up with. joel

I only have one slot 20mm ramped from full depth to nothing. I'm sorry I thought you meant 80 ipm just didn't think. I think I will try .002"doc with .0002 ipt. Thank you for all your help. It will be a couple of hours before I cut it so If you think of anything else please let me know. One other thing should I use coolant or air? joel