Search the Community
Showing results for tags 'axis substitution'.
-
Hello all, I am new to Mastercam. I just started learning mastercam 4th axis from the pdf of mastercam 5axis. THe tool in 2axis, follows the 2D path perfectly. But in 4th axis, the path of tool and the tool path does not match. I am attaching few screenshots, to understand this better. ss_1 : toolpath looks good. It's in the wireframe, proper place. ss_2 Going to verify now. ss_3 Is not starting where I wanted. ss_5 is completed pocket. ss_4 the axis rotated and now the pocket is in the place. What is happening here?
- 6 replies
-
- axis substitution
- rolldie
- (and 5 more)
-
Another GoPro Video. This time rotary peel milling on our VM3 with HRT210 4 axis. Using axis substitution. Material: A2: Tool: 3/8 IMCO power feed .02CR 600 SFM (6112 RPM) .004 FPT (146.69 IPM) 7% Step over (.027) .570 DOC
- 15 replies
-
- 9
-
Any ideas on how to tackle this part, all I have to do is a .375D slot .09Deep and a 60Deg Chamfer around its edge (x50). Any suggestions, I have used a simple contout with Comp off, and created the center line at height to drive it, then swept a surface using the upper and lower rail to run a flowline path on the chamfer. Any suggestions, wanna use the best path available. Thx !
- 24 replies
-
- 3D slot
- 3D chamfer
-
(and 4 more)
Tagged with:
Join us!
eMastercam - your online source for all things Mastercam.
Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.