Arc Filter setting

[G Caputo]

foolsh,

Take a look at this thread web page and see if that helps, or maybe I am way off base and not functioning correctly thius morning.

[foolsh]

G Caputo,nothing gained from that thread as the file c615901.mc9 was nowhere to be found in the ftp site!

[foolsh]

although i tried everything this arc endpoint incorrect warning in a Heidenhain tnc 430 or tnc530 still refuse to go away.i was using a surface roughing pocket with a 4 mm cutter.it only goes away after i use a 3 mm cutter!can anybody please offer some assistance?i have tried changing total tolerance to 0.05mm with filter on xy plane,minimum arc radius 0.2mm ,maximum arc radius 100mm,tried reducing cutter to 3.99mm,offsetting tool boundary more than 2mm using tool center boundary.changing the post too doesn't help,i have changed break arcs at quadrants.nothing works

[foolsh]

yahoo!finally i found it myself!there were 3 self intersecting surfaces in the workpiece.after i have patched up the surfaces and run the post again with and without the patched surfaces,the stupid circle endpoints incorrect error was gone!it seems the Heidenhain tnc 430 and 530 threw up this alarm but not the fanuc controller!