cadist
-
Posts
846 -
Joined
-
Last visited
cadist's Achievements
Newbie (1/14)
13
Reputation
-
Depth cuts goes in Z-axis direction, And multipasses in X&Y. Usually for undercut grooving we use multipass. and depth cuts for anything else
-
Yeah it is normally generated in Siemens NX. If there is a single file you can mail me and I will convert this to dxf or dwg for you.
-
The biggest surprise for me was removal of coons when I moved to X3, the net surface is far better and easy to use command, in many case simple selection of window and surface is ready, Not even in NX or Solidworks have such ease of use.
-
Laptops always have screen-size constrains, wait for next gen ipad which could run all our sw. In my opinion Sony is always better.
-
HELLO ALL I don't think it is possible in any other software with filleted sketch you can not have same radius on drafted wall. CMIIW
-
create -- arc --circ rad If I remember that right.
-
To finish only curve portion you can create a circle on top of the model and select that as containment boudary. so it will limit the movement of the tool.
-
Its been ages since I used v9 but I remember after selecting pocket you have to select all surfaces or solid then click on done.
-
may I know which toolpath you are creating? After selecting your toolpath you should select the whole model.
-
Just rotate your pary or part whatever you call it with xform rotate. set it in similar way as it would appear on the machine.
-
set all of them to "t" by clicking on them
-
your construction plane should be the same as your gview, normally its top. you can change that from the parameter from toolpath there is an option called plane click on that and make all plane top.
-
My friend is reseller of Haimer products in our region he has his own shop and uses one shrink fit. He is very satisfied with his performance.
-
Too expensive to do it on CNC milling, girnding machine does the job very well and cheaply.
-
With 48Rc I always prefer semi-finish leaving 0.1mm stock, so the finishing is consistent.