2020 Dirty Toolpaths w No Changes Made

[Therin]

I open the toolpath just to look at some of the parameters and i close out of it without changing anything and it dirtys it? Mostly does it on the multiaxis, rest machining and dynamic toolpaths and its a pain, especailly when theyre pretty big toolpaths and connected to some stock models. Is there a way to fix this? Thanks

[crazy^millman]

Just now, Therin said:

I open the toolpath just to look at some of the parameters and i close out of it without changing anything and it dirtys it? Mostly does it on the multiaxis, rest machining and dynamic toolpaths and its a pain, especailly when theyre pretty big toolpaths and connected to some stock models. Is there a way to fix this? Thanks

Don't hit the green check mark when closing? There is way to make this happen depending on how you close the operation. It was either the Green Check mark or the blue plus that did make this happen or didn't make this happen. Also need to make sure the MCAM folder in Program files has full permissions.

[Guest]

Maybe download this add-in by Gunther, it does the regen automatically when exiting the parameters dialog.

 

Like millman says, I usually hit escape out of the dialog if nothing changed

[jeff]

Yep, ESC or hit the Red X.  

I learned that lesson quickly.