Quadro settings

[Diablo God]

Atm I have a dual xeon 2.8, 2 gig of ram, with a quadro fx1000 from pny ( http://www.pny.com/products/quadro/fx/1000fx.asp )

 

But my dynamic rotations on not so hard geomtry seems to be sluggish. And I can not figure it out.

 

Yet on the computer next to me, with a 2.4 gig chip with 1 gig of ram and a pny 750 xgl runs so much better then this one. This is on winxp pro, the other on win2k.

 

Both systems on mastercam 8.1

 

I am hoping there is a setting to turn up the graphics card that I am missing. Anyone have any ideas as to what settings to change to get a boost out of this system. I tried there stock solidworks settings on the nvdia manager. someone mentioned this on the forums along time ago. But still not the performance I should have.

 

 

Jim

[neil qwerty]

Jim, you might want to try turning open gl either on or off. In mastercam go to screen, configure, click on the screen tab, and pick "enable open gl drawing".

 

Hope this helps.

Neil.

[Camdude®]

jim,

go to your compatability wizaed in the accessories page and set mastercam to run in Win2000 pro. this has helped my customers in the past.

[Diablo God]

Tried both, system still is not running like a hotrod like it should be :/

 

Jim