Machine simulation collision check tool vs. workpiece

[Davor]

Hi,

I made machine simulation and I get collision check between tool and workpiece. In machine simulation when tool go into the wokrpiece they doesn't signal to collision. Collision between tool and fixtuere, between tool and C-axis work fine. What I do wrong? Pic in attachment

[crazy^millman]

Huh? You want a collision between the cutting tool and the part it is cutting? Are you asking about the holder and the work-piece? If that is the case then set holder to work-piece in the collision.

[Davor]

Yes I want set collision between holder and workpiece but in settings to choose I do not have options "holder". I can set only "tool". In tool segments is holder, arbor, shaft and flute.  In attachments is picture. How can I separate holder and tool? 

[crazy^millman]

Not sure I have never had that problem. Need to reach out to your Mastercam Reseller and they can take a look and help you narrow it down.

[byte]

4 hours ago, Davor said:

Yes I want set collision between holder and workpiece but in settings to choose I do not have options "holder". I can set only "tool". In tool segments is holder, arbor, shaft and flute.  In attachments is picture. How can I separate holder and tool? 

Hi, please validate in the tool manager that your tool is stored in an assembly and that the assembly contains the required components, if your tool assembly does not contain a holder component, you may not see it in the list

[Jobnt]

1 hour ago, byte said:

if your tool assembly does not contain a holder component, you may not see it in the list

Can you define a holder at the same size as the shank?

[byte]

39 minutes ago, Jobnt said:

Can you define a holder at the same size as the shank?

Yes, you can define a holder the same size of the shank

[Craig-B]

Just a note, make sure you have this checked in the Machine Simulation Options. This was not checked and was giving the same result you have with another user.