CY_Deburr_error@MPLMASTER

[Alan Chen]

Is there anyone who encountered this situation?

I use Lathe with Mill 5-Axis Deburr.

That NC code look like error, X value immediately changes from a positive value to a negative value.
And some X value was -6.605, then move to -26.861 ?
In this case, the X position must be positive, because cutting on righe side.

And I use deburr machine one place  and then use the C-axis to generate other paths.
The nc code all wrong the same with first.

Thank for your help.

[email protected] [email protected]

[ajmer]

the only way to do this is to save the deburr operation backplot as geometry

then do a C axis face contour on that geometry 

then the post will post as C and X or if using G112 it will output correctly

 

[Alan Chen]

16 hours ago, ajmer said:

the only way to do this is to save the deburr operation backplot as geometry

then do a C axis face contour on that geometry 

then the post will post as C and X or if using G112 it will output correctly

 

Yes.

I use save the deburr operation backplot as geometry, then output the NC code.

 

But I think the MPLmaster maybe will be update with deburr operation.

[crazy^millman]

On 4/15/2024 at 5:08 AM, Alan Chen said:

Yes.

I use save the deburr operation backplot as geometry, then output the NC code.

 

But I think the MPLmaster maybe will be update with deburr operation.

I would think not. Will need to purchase a custom post to get what you are asking for. Only so much a free post will get you.