"Level " out of order.

[Lstar]

My mcam V9.1 is "Level" and "Mask" in the second menu are not function at all , Any help is appriciated

[Teh Bear without Brains kinda idiot]

Welcome to the board ,Lstar !

 

In screen->config->screen ----uncheck:::> enter level in the prompt area .

HTH

WTHH

[Lstar]

In the...config->screen , its already uncheck for enter level in the prompt area ! what's other problem?

[pip]

Above aformentioned box select "all layers"

[Lstar]

it is selected "All levels". when i click on it, it doesn't come out a dialog box and "mask" too. I think it is not configuration file problem,as the file in other pc works well. maybe windows problem. anyone know more about it please tell......

[Teh Bear without Brains kinda idiot]

Rename your mill9.cfg or mill9m,cfg for metric to mill9bad.cfg.

start Mastercam .

It will generate new ,standart mill9.cfg or mill9m.cfg and try with it .

If it will not help ,dig into CNCreg program to register needed dll components

 

HTH

WTHH

[Lstar]

Thanks Winnie, I've generated new mill9.cfg and mill9m.cfg by deleted the old one, but they are still not working. Tell me how to register the dll (what dll need to register)in the CNCreg.

[JSP Mold]

I also just started having the same problem. The levels dialog box does not come up anymore. I am also having a problem with all of the dialog boxes in the File menu. Example: File, Get...no dialog box shows up.

 

All of the other dialog boxes seem to working just fine. I have already tryed to un-install and then re-install Mastercam, but that didn't help. I am guessing that this is a Windows problem. Anyone have any ideas on how I can get this corrected??

 

-Mike-

[Roger Martin from CNC Software]

Try this for the Levels and File Get dialogs.

In your (Windows) Start, Programs, Mastercam 9.1 group you should have a ‘CNC REG’ shortcut.

(If you cannot find the shortcut, navigate into the folder where you have MC installed and find the CNCReg.EXE file and execute it)

Once the CNC RegEdit utility is up make sure the “Installed Product” setting is set to the correct product!

In the "File Get Dialog' group click on the RESET button.

In the "Dialog Position" group at the bottom of the CNC RegEdit dialog select the ‘Levels Dialog’ and click on the REST button to the right, then click on Apply and exit CNC RegEdit.