Predator virtual CNC

[Jim Whipple]

Hello All, I've been off this list for awhile but am back programming with Mastercam again! Where I work now, they used Gibbs for about 8 years and have made the change to Mastercam. YES!!!!

My problem is that I mave a few thousand legacy NC files that were done in Gibbs, there is very little info as to rev levels etc in the header of the code or what the heck op this file does

Sooo... I've downloaded the demo of Predator to see if I can't make some sense of this mess. I have not heard anything back from the Predator folks in a week and a half or so and thought I remembered someone here being a dealer or rep for Predator...

Might have been Jay, if memory serves

Problem is I need the password to open the demo and install it

any help would be appreciated

And ...Nice to be back!

Jim

[Hardmill]

quote:

---

Might have been Jay, if memory serves

---

Yes e-mail Jay.

 

PEACE

[cadcam]

Jim I will follow-up with you on monday to get you an evail to test and run.

 

you to Hardmill.