arc output with threadmill op

[somename75]

Hello all, I am having a tough time getting arc outputs when doing a threadmill operation. I get point to point XYZ, when I would like a G3 I ### Z### move. The point to point method is waaaay too large for my control. I cant find any filter setting in the threadmill parameters. Any help much apreaciated.

 

Thanks

[Craig-B]

somename75

 

Make sure you dont have the linearize helixes checked under your threadmill tab.

[Craig-B]

somename75

 

Also check you post settings.

 

arcoutput : 0 #0 = IJK, 1 = R no sign, 2 = R signed neg. over 180

arctype : 1 #Arc center 1=abs, 2=St-Ctr, 3=Ctr-St, 4=unsigned inc.

do_full_arc : 1 #Allow full circle output? 0=no, 1=yes

helix_arc : 1 #Support helix arc output, 0=no, 1=all planes, 2=XY plane only

[somename75]

k, will check that thanks Craig