post problem

[IZN]

When I run the mphur post, on a contour, the program feeds down on the first level and rapids down to the remaining levels.

I would like it to feed down to all levels.

I tried posting it with some different posts and they all work properly.

[crazy^millman]

I have seen this before send a copy of your post to your dealer and they should fix you right up. Send them the file, smaple NC code, and the post and that will help them to help you.

 

HTH

[Tim Johnson]

Set your fastmode in your post to no and put the G-code segments of where it works and where it doesn't work on this thread.

[IZN]

Is this what you need?

 

 

% 32

N100 G70 G75 G90 32

N102 G0 T1 M6 32

N104 G0 X.15 Y0. 32

N106 S1069 M3 32

N108 Z.25 32

N110 Z.1 36

N112 G1 Z-.1 F6.4 38 (this is where it works)

N114 X.25 40

N116 G3 X-.25 I0. J0. 42

N118 G3 X.25 I0. J0. 44

N120 G1 X.15 46

N122 G0 Z-.2 64 (this is where it doesn't)

[heywood]

I have the same problem. I just make sure the

tool is out of the part, with lead in lead out, when the Z axis moves down. It's a pain but it will keep you from crashing the tool into the part.