4 AXIS PART

[Lathe-Mill]

Hello peeps, I have a part on the FTP name 6017206 rev.a-op.2 it's on the mcx folder.

i have done similar work in version 9.1 sp2, but for some reason i have a biatch of the time get it done in mcx,the problem is with the slot.

all i'm doing is putting a 1/8 endmill to follow a contour using the rotary table...so far no success. any help will be appreciated very much. tahnx

[Reece L Gibson]

I took a look at the file. Have made a few examples for you to look at.Can not access the FTP site for some reason. Will try in the morning. I can E-mail it, but it's about a meg big.

[Mike@Dive Lab Inc.]

I put a file 4ax ORING GROOVE MW on the FTP in the MCX file, it is a o-ring groove that follows the contor of the part, this may help

 

Mike

[Lathe-Mill]

Reece and Mike, thanx for your help, i just was a bit lost with all the clicking in mcam x i forgot to check the unroll box and also the plane.

again thank you .

[Reece L Gibson]

Your Welcome!