Crashes making WCS

[Cuda84]

This just started happening today. When I select the geometry to make a new WCS I get this error message and MasterCam crashes. "Failed to load resources from resource file please check your setup" This dose not happen every time I make a new WCS just about every second or third time. I have 12 different parts in this file and I am machining each part in it's tooling position. That is standard procedure here, when changes occure, and they always do, we just read in the new part right on top of the original. Dose anyone have any ideas?

 

I also had a new hard drive installed last Friday, but I did not have any problems until today.

[toolall1]

try planes ,origin,pick your point name it ect.

[Cuda84]

Is there a way to align my axis doing it this way?

[gcode]

quote:

---

That is standard procedure here, when changes occure, and they always do, we just read in the new part right on top of the original

---

Is it possible that you have 2 copies of the same solid on active levels?? or 2 copies of the geoemtery you are trying to select?? If so

maybe X is getting brain damage trying to figure out which solid (or line) to use??

 

Just a thought

[Cuda84]

It's definitly getting brain damage. I have each part on a seperate level, and only one level active at a time. Do you think maybe too many WCS's in one file? I need 2 for each part.