Create\Drafting\Hatch

[Rory]

Hello again,

I am creating a drawing with section views,

I add hatch marks for aluminum and save the file.

When I reopen the file later to continue working, the hatch marks do not come back in and I get an error message "Corrupt entities were not brought in".

I first created this drawing with Mastercam Draft V8. on a different computer.

I am now working with Mill level 2, because it is on a different computer that is hooked up to the plotter.

Any ideas?

Thanks,

Rory

[Glenn Bouman]

That has been fixed in V8.1.1

You can get the patch here: http://www.emastercam.com/patches/v8/

[Rory]

Glenn,

Thanks much for the reply.

Are there any files that will be replaced that I should back up first?

Rory

[Glenn Bouman]

Just copy and run the patch file from the MCAM8 dir