MC X MR2 lathe canned cycle prob.

[Don S at Barefoot CNC South]

Canned rough cycle in MR 2 not working here. It works ok in MC 9 missing values

code:

---

 (TOOL-1. OFFSET - 1)

( DDJNR-164D - DNMG-432 INSERT - DNMG-432)

G0T0101

G97S266M03

G0G54X2.875Z.0616M8

G50S3600

G96S200

G71U0.R0.<--------------no values being posted

G71P100Q110U0.W0.F.003 <------ same here

N100G01X.3403S200

G1X1.5Z-.5183

Z-36.

X2.5275

G3X2.6087Z-36.02R.0513

N110G1X2.875

M9

G00X8.Z8.M05

T0100

M30

---

same program and post works fine in MC 9

[Don S at Barefoot CNC South]

bump

[Guest]

Simliar problem Don?

Linky

[CR]

Hi Don

Having the same problem here

 

G0Z1.X2.6M8

Z.1

G71U0.R0.*********missing U R values

G71P21Q23U0.W0.F.008 ****missing U W values

N21G0X1.381

 

Also

When the G71 info is included in one single line

 

G0X2.05Z1.M8

Z.15

G71P11Q13U.01W.003D0.F.008******missing D value

N11G0X.7

 

Looks like I need to work in my X post

Thanks John

[Don S at Barefoot CNC South]

I made all the changes in my X post like the link says and its still not working?

[Jim Evans from CNC Software]

Make sure you have made the changes to the parameters numbers for X. The link above has good information, but you can also compare it to the generic lathe posts that come with X.

 

Make sure you have the Write NC operation information check box active in your control definition (Files topic). Without this on, the parameters will not be read causing U, R, etc to be zero.

 

If you have done all of these, please use zip2go and send your files to [email protected].

 

It seems to be working on our generic posts just fine.

[Don S at Barefoot CNC South]

Thanks Jim that was the problem.

quote:

---

Make sure you have the Write NC operation information check box active in your control definition (Files topic). Without this on, the parameters will not be read causing U, R, etc to be zero.

---