Coolant defaults

[Mcam Nut]

I have my coolant set to being on with flood coolant in the operation defaults, and the coolant is not defaulting to being on, I have to select it to be on for every operation. This hasnt hapened to me before mr2, and my settings are the same. is there somthing i am missing?

[Steve Zirtzman]

McamNut,

Check your settings on the Coolant commands tab under General Machine Parameters in your Machine Definition.

[Mcam Nut]

My settings under coolant commands are the same as they always were, somthing else must of got messed up but i dont know where to look exept in the operation defaults, and coolant commands

[Scott B]

Are you using tool,peck,coolant in the "files" under machine proterties in the operation manager? If so check to make sure the coolant is turned in the tools parameters

[Scott B]

Sorry that should be under "Tool Settings" in the machine gruops properties.

[Mcam Nut]

Ok, it was checked to use my tool settings, with it unchecked it works fine. I know this is probally right in front of me, but I cant seem to be able to find it. Where do I set my defaults not to use the tool peck, and coolant?

[Steve Zirtzman]

Machine Group Properties-Operation Defaults-Properties-Tool Settings tab.