X2 Mill Point toolpath

[JDowe]

I think I recall being able to use point toolpaths to create toolpaths from point to point and being able to add coolant - spindle

and stops at different points and being

able to edit these commands and points later

but either I don't recall correctely or I just can't locate these in X2 - I see the point to

point creation but not the spindle - coolant commands

 

Thanks for the help

[Bruce Gibson]

It is in the toolpath editor.

[Guest]

There is a point path available

 

Click poitn and click the green check the toolpath dialog box will come up

[P_Scott]

JDowe,

 

You must mean MR2 because "X2" is still in Beta development stage. The Point toolpath will allow you to select the coolant and feed options from the general parameters of the operation or geometry. If you want to do other things, right-click on the Point operation after you have one and select the Toolpath Editor at the bottom of the right-click menu. This will give you some of the other options you were asking about for the Point toolpath. HTH

 

[JDowe]

Thanks everyone