OKUMA I.G.F

[Lathe-Mill]

we have a couple of crown lathes, the operator is on vacation and he only uses floppys to save the I.G.F files, some floppys are missing now, the question is;

is there any software that will allow me to save copys of these 10 or 15 floppys?

we need some kind of back up system here, any help will be appreciated a lot.

thanx.

[New Job]

For our machines that use floppies we just stick'em in the old pc and make copy.

[Lathe-Mill]

that will be nice and easy, but okuma floppys they are format to okuma i.g.f format, when you put the floppy in the pc, it ask you to format the floppy to pc.; it does not recognize the format.

thnx

[T_MALENA]

I think you need to use Norton utilities to access the floppy in Okuma format.

[Rick Henrickson The Boeing Co.]

you can load them into your floppy on the machine and copy them onto a new disk after you format it in OSP if you need some help I can send you a manual I wrote for them.

easy to folloe procedures!

email me @ [email protected]

[Lathe-Mill]

sure rick, that will be nice, thanx.

tmalena,thanx for the tip.