X2 Error report--toolbar defs

[lynnz]

When starting up X2, an error report pops up about reading toolbar definitions. I'm not sure if this has been covered yet or not. I can close out the error dialog box and go on OK. But what is out of whack to cause it to pop up on startup??

 

Error (L692;C:mcamx2configmastercam.mtb);SPECIFIED command not found.

Error L693 " "

Error L694 " "

Error L695 " "

finished reading toolbar definitions...

 

I'm running XP Pro x64. Didn't have any problems like this with X or mr2.

 

Thanks

lynnz

[Guest]

I'd guess you migrated your toolbar from MR2 to X2.

 

There is something on the toolbar that X2 cannot find so it puts out the error.

 

 

If you are not sure what it is, open the .mtb file the mastercam editor, number the lines and find what it is, you can then eith ether delete them or fix what ever it is that's missing.

 

I have had chooks mostly cause this problem for me.

[Thad]

Lynn,

 

Print off a screen shot of your MR2 toolbars and then compare them to what you get after OKing through the error in X2. The All-Result chook was giving me problems. I copied them to the X2 install folder and all was good.

 

Thad

[lynnz]

Thanks for the help. I'll give that a try.

I forgot to say, but I did a side by side install of X2 along MR2.

 

lynnz

[lynnz]

Problem solved.

I hadn't moved the X+ chook over yet. Did that and error is gone.

Thanks again.

lynnz