drill point selection

[perseid88]

In the drill point selection when I create a bolt circle pattern, it sure would be nice to be able to "tab" from one box to the next.

Radius-tab-start angle-tab-angle between-tab-number of holes

 

But tab doesn't work. I have to DOUBLE click each box before I can enter my value. Why is that?

[?Mark]

quote:

---

But tab doesn't work

---

Works well here. In X2 math functions are back also...

hth

[perseid88]

Can anyone confirm that in MX it was not working, or is it me?

[Nathan G. Baldwin]

quote:

---

In X2 math functions are back also...

---

Yay! I hadn't checked that yet.

[LaszloK]

The "tab" works for me as well as "enter" after each entry.

[perseid88]

Enter gives me the same non-results. I see a quick flash of a message in the workspace that I think says point sorting-OFF, Duplicate point filter-OFF but I get no cursor to keep typing. I must click once to re-activate the drill point selection box and again to highlight my particular entry box.

 

MX MR1 XP Pro 3.2GHz P4 1.00G RAM

Video

ATI Mobility Radeon 9600 8x AGP w/128MB video memory

[Guest]

quote:

---

ATI Mobility Radeon 9600

---

Bingo, I got bingo here.

 

Seriously that vid card is going to be quirky. It might work sometimes and others iyou will see some strange behavior.

[Span]

If you're refering to the bolt circle in the drill point selection box. Yes, it does do that and it is sort of annoying. I had forgotten that was there, I've always used the create bolt circle command then selected the points.