Post not showing up

[DaveR]

I made a copy of my Haas post (mcam/mill/posts)and made some changes. It's not showing up when I go and try to select a machine. What do I need to do?

 

I did a search for the subject of post not showing up but nothing turned up. If this has been covered before sorry, can you point me to the thread.

 

Thanks

 

Dave

[gcode]

Check out page 849 in the Reference Guide

in C:mcamxdocumentation.

It will walk you through what you need to do

[Bryan Johnson]

check that the file extension of the new copy is still .PST

[DaveR]

Thanks for the help.

 

Dave

[DaveR]

gcode. I just went through all of the help .pdfs and none of them have over about 400 pgs. Which file should I look at?

 

 

edit

 

I found it, pg 215 ref guide. Don't understand it but I found it.

[Guest]

Dave,

 

Machine Def >> edit control def >> click on the post processors button >> add files >> Pick the post you want to add >> click on that file now in the lest and press the green check >> make sure the post you picked shows >> click the save button

 

Now you can click the post processors button again and delete the old post and after the green check save again >> save all t he way out, reload you machine def and the new post should NOW be the active post.

 

HTH

[gcode]

quote:

---

I just went through all of the help .pdfs

---

Its not in the help, its in the Reference Guide

Go to

C:mcamxdocumentationMCAMX2_RefGuide.pdf

page 849

 

If you don't have a folder named C:mcamx

look for C:mcamx2

 

There are a half dozen manuals and guides in the

documentation folder. All of them are worth checking out

[DaveR]

Appreciate the help John and Gcode.

 

 

Dave