definitive Mastercam job plan / setup sheet?

[kkominiarek]

What is the definitive Mastercam job plan / setup sheet? Something that is associative to the model geometry. Every time I “get” geometry file # 1212, all of the following information is with the file. If I am not available and some one else needs to “get” a program from my workstation they won’t have to guess what a program does, or what revision it is, all this information will be there for them to look at.

 

Company:

Print #: rev:

 

Part description:

 

Units:

Material: Size:

 

Programmed by:

 

Program Zero location:

Program #:

DNC ID:

 

Define operations:

Define tools:

 

(notes)

how to hold part

change clamps at “M00”

what the program machines

change tool 3 every 4 parts

 

etc….etc…..etc….

 

It's important to give the guy's on the shop floor

the infomation needed to run a job. Something that they can verify against their job paperwork.

I hope there is an answer to this question.

 

As always your time in answering these questions is appreciated.

[cadcam]

Have you looked at the HTML setup sheet.

You can get with in-house on make the change to the formate just the way you want it?

[Scott Bond]

This is a new program I made yesterday.

The information clues in the set up man,

For this first run and 2 weeks from now

when I forget everything that I did.

Also the notes at each operation , spell

out the task as complete as possible.

 

%

O1111(xxxxxx 9-25143-1 OP-1 AND OP-2 RV:C)

(FORMAT---------: HAAS FOR xxxxx BROTHERS)

(DATE ------------------------ 02-26-2002)

(TIME ----------------------------- 09:36)

(*)

(MATERIAL:---------------- ALUMINUM ALLOY)

(STOCK SIZE::::-- X=6.375,Y=3.500,Z=3.500)

(NET PART SIZE:-- X=5.857,Y=3.000,Z=2.300)

(HOME POSTION IS-- TAKEN FROM TOP OF PART)

(HOME ------COORIDNATES ARE THE FOLLOWING)

(X= CENTER OF THE--------- 2.000 DIAMETER)

(Y= CENTER OF THE--------- 2.000 DIAMETER)

(Z= TOP OF PART IS-.350 FROM TOP OF STOCK)

(USE THE SAME PROGRAM FOR OP-2 EXCEPT FOR)

(ONE;; IT MUST BE IN CUSTOM JAWS---------)

(AND TWO THERE'S NO NEED TO RUN TOOLS 1&2)

(*)

(----------USING FIXTURE OFFSET G111-----)

(*)

( TOOL-1 --- .750 SPOT DRILL 1.000 LONG)

( TOOL-2 --- 1.000 ENTRY DRILL 3.000 LONG)

( TOOL-3 --- 1.000 ROUGH E.M. 1.400 LONG)

( TOOL-4 --- 1.000 FINISH E.M. 1.400 LONG)

( TOOL-5 --- .500 SPOT DRILL FOR CHAMFER)

( TOOL-6 --- .250 SPOT DRILL FOR, DEBURR)

(*)

[cadcam]

test

 

[ 02-27-2002, 03:52 PM: Message edited by: cadcam ]

[bryan.davis]

you failed 0/10 very poor performance SEE ME!!