V9 Post Error Log File

[kathy]

Hello Everyone!

 

I've updated my post to Version 9, and with the latest V9, I get .err files with every post and Setup Sheet creation. Anoying.

 

I did set up my 'Fadal' post as error_msg :1, but I can't find a good line to put it on to make it work. In my 'Komo' post, I put the variable in the Formula Section, and it works there!. Huh!!

 

Any Clue?

 

Kathy

 

I just ran a couple more 'Komo' files, and I'm still getting the .err files. I based the abouve on a test I ran of just one post fiel. The .err file only contain "Combined Mill and Lathe Post Processor Version 9.00r © Copyright 1992-2002 CNC Software, Inc.

Processing file with KOMO..."

 

[ 03-03-2002, 06:31 PM: Message edited by: kathy ]

[Glenn Bouman]

The MP.DLL has been updated to remove non-critical error messages.

 

It is in the addons file at:

http://www.emastercam.com/patches/v9/