Post doesn't spillout I and J Please help

[Jorge Brito]

for some reason I can't get I and J on Mastercam MR2 when I post a program. However I got I and J when I post on Mastercam 9. Yes, I am using the same post in both versions. Please let me know how to change it. Thank you!!!!!!!!

[Guest]

In your control def for X you need to the >> arc to delta start to center, that should get it for you.

 

hth

[Jorge Brito]

I don't see that defenition on Control Machine definition. ONly support arcs in different planes and nothing from the center.

thank you

[Guest]

There is a selection area for Arc center type with 3 pull downs, they need to be set there.

[Mgrenier]

Jorge,

 

In the arc page of your control definition fint the section that says Arc center type and make sur it is set to Delta start to center or Delta center to start depending on what your machine needs. Don't forget to ajust for all the planes that need it.

 

Hope that helps,

 

Martin

[Jorge Brito]

thnak you I got it.

[heavychevy2155]

Man you guys were all over that one.