Surfacing Help

[fiatspider]

Hello,

I am working on an anti-roll system for a racecar that I am building as a club at Georgia Intsitute of Technology, and I am having some trouble. On this part I am having trouble getting the countour surfacing to remove the unneeded cuts from the bottom of the part, I have tried the remove cuts from shallow areas with no luck. Anyone else have any ideas? Or should I try a different type of surfacing, I have tried quite a few and nothing else seems to be nearly as efficient as this one, even the flowline was having lots of problems. The file can be downloaded from, ftp://mastercam:[email protected]/Ma...R_ANTI_ROLL.MC9

 

Thanks for the help,

[Matt Niadna]

Go to the "Finish contour parameters" page in your tool path. Click on the "cut depths" button. Select Absolute. Make your Minimum depth 1.0 and your Maximum depth 0.0. This will give what your looking for.

[cadcam]

fiatspider go on the FTP and get your file that I have added CADCAM to.

I did waht mat said for you see if this what you want.

I think mat hit on the head.

 

[ 03-27-2002, 10:59 AM: Message edited by: cadcam ]

[fiatspider]

To Jay and Matt,

Thank you both very much for taking the time for answering my questions. That was exactly what I needed,