http://www.tools-n-gizmos.com/specs/Tapers.html

Everyone I talked to so far, mills it. Including Fadal service.

I found of shop that can cut the turcite on my table. Does anyone know the size and thickness that Fadal uses for the saddle and table? I qot a price on the turcite kit from Fadal. I want to see what it will cost if I order it from a Turcite supplier.

Turcite won't be flat once you glue it on. You also need to cut oil grooves in it.

I recently purchased a Fadal 4020. Before I start running it, I want to replace the Turcite on the table. Does anyone know of anyone the Reading, Pennsylvania area that can machine the Turcite after I install it? Thanks,

Anyone have any experience with one of these? I am thinking about buying one to do some milling with a 1mm ball in aluminum. It is the cheapest Speeder that I have seen. ATC-Mac

Anyone know where I can get a TR20x5 tap custom ground, or find a thread mill? Thanks

That's what I'm thinking... I was thinking about doing it in 12" wide sections, so the plates would be easier to manage.

I just purchased a Fadal 4020 HT. The machine is in good condition except the table is worn. Is there any way to resurface the table while it is on the machine? If I can't find a resonable solution, I think, I am just going to mount an aluminum sub plate to it. Thanks,

Can someone tell me what software uses the *.GEO extension?

Thanks Avs_Fan I was thinking about trying that...

I need to cut o-ring grooves in the face of a part. 2.5" diameter .08" wide, .09" deep. I am looking for a holder similar to an adjustable boring head that will take an insert. I have found one manufacturer: atptools.com Does anyone know of any other manufacturers? Thanks

I have a 1997 Haas VMC that has a processor board that is going bad. I have bought a new board, but I can't find any documentation on removing the control software from the old board and installing it on the new one. The parameters and settings, I can do. Anyone have any experience with this?

The company I currently work for is looking into purchasing a 5 axis router to cut secondary operation and check fixtures out of RenShape. I know little about 5 axis machines. The companies I have contacted already are: Shoda, Thermwood, DMS, and Quintax. Can anyone give me some input on machine makers, quality, and service?

Is there Palm OS or Windows CE based DNC out there? I could of swore I saw a Palm based one before...... Thanks, Matt N.