X+ Question

[JAMES GABEL]

I want to setup a setup sheet on one piece of paper. I have made a excel sheet to a format that I like. Is it possible to have X+ put the information the cells that I made. If so, how do I do that. I have been using inhouse solutions setup sheets which are nice but to much paper. I just need the info on one page. Any help would be appreciated.

[JAMES GABEL]

bump

[Guest]

James, using the In-House, if you open it up and set these

 

code:

---

list_type    : 2   # Operation List style - Full parameter box frequency [0=Toolchange,1=Operation,2=Remove section]

---

and this

 

code:

---

stock_img  : 0     # 0 = No screen capture image

# 1 = EMF: auto image cap, fast run, large file size, bad on-screen, prints perfectly - not supported by Firefox/Mozilla

# 2 = PNG: auto image cap, slow run, small file size, clean on-screen, prints reasonably

# 3 = GIF: auto image cap, slow run, small file size, clean on-screen, prints reasonably

# 4 = GIF: manual image cap, searches for pre-existing GIF

# [NC_directory][ncfilename].[sextgif] for file_naming = 0

# [MCX_directory][mcxfilename].[sextgif] for file_naming = 1

# [MCX_directory][ncfilename].[sextgif] for file_naming = 2

# 5 = PNG: manual image cap, searches for pre-existing PNG (e.g. from X+ SnapShot C-Hook -

http://www.gmccs.de/)

# [NC_directory][ncfilename].[sextpng] for file_naming = 0

# [MCX_directory][mcxfilename].[sextpng] for file_naming = 1

# [MCX_directory][ncfilename].[sextpng] for file_naming = 2

---

You'll get ONLY the tool listing and the header info a MUCH shorter output

 

hth