X3 ops losing tools?

[Dracbus]

I have been using X3 for about a week now or so and i was wondering if anyone else has noticed that every once in a while when you go into the parameters of an op to make a simple change or even if u dont change anything it asks u if you want to update your tool. Almost like you had changed your tool when u actually didnt do anything to the tool. And if u hit yes to update the tool it turns any of your Ops that use that tool into a dirty OP and makes u regen it. And if u hit no then u have to go back in and make your changes that you had already made once. And usually it doosnt do it the second time you make the changes. I havnt changed any settings since x2 mr2. At first i thought it was only my old files that were doing it but after i started to make new files and it was still doing it i started to doubt that was the case. Anyone else noticing little glitches like this in x3?

[Leigh @ Kodiak]

Yes, I am noticing the same issue you are describing.

[1 master]

i hope they fix it with sp1

[JDowe]

It seems to happen when adv multiaxis

toolpaths are selected - it always replaces

the tool with a center drill then asks to update

the toolpathsif the

center drill is deleted and the original

endmill is selected it gives an error until

that tool is reselected