md/cd video

[Rakesh]

Hi everybody

Last year or so I watched the workshop video on md/cd topic and I want to watch it again. Now my problem is I could not remember from which site I got it. This was the workshop video specially on md/cd. I want to watch again especially the section where they explain about control topic, import pages for post setting for control definition. If any body know where I can find this. This video is not the one which is on mastercam.com site(2 videos) and also not the one which is on streaming teacher(6222 topic).

If any body have any clue

Thanks

[Bobkat]

Hi Rakesh

 

Could it have been part of the

workshop video series section on Streamingteacher.com

If it was, the video segment numbers might be

ws1006a and ws1006b

 

Those 2 videos go much deeper into md/cd than video #6222

 

B

[Rakesh]

I have x3 subscription and I could not find ws1006a topic. Is any thing I am missing?

May be this topic is removed from x3 subscription

[Rakesh]

Bobkat

I could not find this video in x3 subscription.

Are you using x3 sub or x2 subscription?

Thanks in advance for your time.

[Bobkat]

I have X2 at the moment,

It might be worth sending them an email asking if they were going to carry any of the work shop videos into X3.

I would imagine that many of them would still be relevant.

Try emailing

[email protected]

 

B

[Trevor Bailey]

the ones on the main Mastercam website are pretty good.

[Bobkat]

Hi Rakesh

 

I just saw that Streamingteacher has added some workshop videos on Machine and Control definitions.

Looks like segment #'s 1014a through 1014h.

I think that these have been updated for X3.

Could this be what you were looking for?

 

B

[Rakesh]

Bobkat,as you suggested on Nov9-2008, I e-mail streamingteacher for these videos and finally they added up. Nice to see these videos and thanks to you for your idea. Lot of informations in there.