mpmaster adding Tool No.

[Wanny]

Hello all,

when I post a single tool operations i have no problems but as soon as I post with multiple tools I get an extra entry on one of my lines calling the nest tool ( Line N160 - T3).

I've just upgraded to X3MU1 from X2 MR2 and I'am using the mpmaster post.

I have looked at both posts from each version and they look the same.

 

All help would be appeciated.

 

Thanks

 

 

N100 G00 G17 G21 G40 G80 G90

N110 T2 M06 (6MM CAR)

N120 (MAX - Z25.)

N130 (MIN - Z-10.5)

N140 M08

N150 G00 G17 G90 G54 X-516.73 Y-212.745 S5500 M03

N160 G43 H2 Z25. T3

N170 Z2.

N180 G94 G01 Z-1. F500.

[gcode]

Go to the Tools Page of your Control Definiton

and turn off Tool Staging

[?Mark]

It's staging the next tool.

You can turn it off in your control definition settings if I remember right.

hth

[Dan@home]

What they said..

[Wanny]

Thanks for your replies, I had a look in the control def and when I unchecked the staging it still had the problem however when I unchecked the "use head no to add to register" this seems to of worked.

Weird because I didn't have this issue in MR2 with the same settings but not worried as seem ok.

 

Thanks again