Printing Problem "unable to generate shaded print"

[VINK]

I have started to have this issue where I cannot print my parts. I keep getting a warning saying"unable to generate shaded print, try a smaller print region and/or a lower dpi or change display mode to wireframe". Here the rub, I am trying to print just a wireframe of a very simple part, not even in color!

 

So is this an issue with Mastercam, my printer (HP L7680 AIO) or the network I am trying to print over?

 

Thanks for any and all help.

[Leigh @ Kodiak]

I had this same problem not to long ago. Restarting my computer solved the problem, and I haven't seen it since

[Bill R]

If you try to print with shading turned on, you will get that error, even if the shaded part is on a level that is not currently displayed.

[VINK]

This particular part is wireframe only. No solids, no surfaces. However, I'd like to print those too!

 

 

I'll give the ol' reboot a shot.

[john316]

.

 

It does that on mine once in a while. I don't have to restart my computer. I just close and re-open Mcam. I assume it's a memory use issue.

 

.