Grouping Operation

[George Gerhard]

Good Morning

I have 5 operations that I would like to apply to geometry simultaneously.

Currently I pick each operation then add the chain.

Is there not a way to have the operations as a group, so I pick the chain once, and all the operations are applied?

thank you

George

[dieselpower1]

I don't think there is anyway to group operations. What I do is select the geometry for the first operation, right click on the geomerty tab in the Ops manager and drag it into the geomerty tab in the next opp. It will ask you to add, replace, or cancel. Add or replace for each operation, then regenerate all dirty operations

.

[George Gerhard]

thank you

[Grumpy Guy]

ditto on the right click!

[Thad]

...or left click.

 

 

Thad

[George Gerhard]

Here is another way

chain your part, now under the tool tab (x4) right click and select get operations. Find your operations to import and select them. Next you will be asked if you want the toolpath group, this is your choice.

After you get the message saying operations have been imported accept the green check twice, and all the operation for that part will be applied at once.

I like it

George