Bull mill issue with dynamic milling

[Bob W.]

When I create dynamic milling toolpaths using a bull mill there is an accuracy discrepancy between backplot and verify. The verify simulates a bull mill cutting too deep by an amount equal to the corner radius of the tool, while backplot simulates the toolpath at the correct depth. Anyone else run accross this? I'm not sure which version will actually post to the machine.

[Todd Tracey from Fastech]

Is comp set to center or tip?? Some of the parameters are defaulted to center

[Bob W.]

It was comped to the center. I changed to tip and all is well :-) Thanks!

[Todd Tracey from Fastech]

Glad I could help