Job Setup Problem

[Mill Man]

Hi Everyone...

I am useing V9 Mill and I post for FADAL. When I

goto Main Menu, Tool Paths, Job Setup. And in Tool Offset Regester - Add and set Height to 0 and Diameter to 0 so the tool, height, and diameter will all have the same number. When I start the next job I have to do it al over again. Who can I save those settings..

 

I hope you understand what I'm talking about...

Thanks

Gary

[d0gFartz]

Change`em in your Screen,Configure,NC Settings

[Chris Parish]

Dog guy is right....

 

Click on, screen, configure, NC settings, Operation defaults, defaults.df9 (for english), then on the right of the operation manger look a like page, click on job setup, set up value for tooling accordingly, remember to click on save before you exit screen, configure....

 

Cparish

[millman2002]

Thanks

That fixed it.