Tool Holder Brain Fart

[pip]

How do I set the tool holder (from Library) in verify. I dont meen the standard Holder, but one from my library (HSK 40 a).

Using X4 HighSpeed Toolpath 5 axis. So I would like to see if my holder hits the part in verify.

I have done this several times, but cant figure it out today.

[Verndog]

I dont know of any way to see holders in verify other then to draw them. Define tool as custom tool and draw tool and holder on its own level, then point custom tool to that level. You can see the holder during backplot and verify this way.

[J Coulston]

In the parameter page select the Toolpath Type -> Tool -> Holder define your holder and save it to the library select the holder, Verify little blue holder with red em toggles the holder on and off, it is the last one on the right under the VCR controls

[J Coulston]

The holder should be part of the tool definition, but it is not, guess it's time for an enhancement request.

[pip]

Back at work, but can't select tool holder in 5th axis toolpaths. Is this corrrect.