knurling toolpaths

[jamjo]

Hello Guys,

 

is there is any option in mastercam which will create knurling toolpaths ??

 

Thanks

ashi

[crazy^millman]

I have always just used a point toolpath, but you could use a finish toolpath. I am assuming this is for a lathe.

 

HTH

[ReDEyZZ]

The Lathe Finish pass toolpath will work, you will have to adjust for the knurling tools gap on X, (assuming it has a top and bottom roller)also, Depth of cut,feeds, and speeds are important to achieve the proper knurl, how coarse are the knurl specs? Do you have the right kind of knurler?? (straight, double-cut, tapered..etc.)

 

Check with the manufacturer for proper SFM and feedrate.

[chris m]

Finish toolpath for us with bump knurling tool; as Jarrett says make sure you get some info from the tool manufacturer if you aren't well versed in knurling [i'm not very savvy so I work the phone whenever I need some help].