X4-MU3 does not like INVENTOR 2010

[kool]

I just install MU3 over MU1. it was running fine, but then i try to open Inventor 2010. Instead of opening Inventor, Master cam installation window pop up saying configuring Master cam X4, after few seconds it give me three option "cancel" "retry" "ignore". I ignore the massage, and Inventor finally open itself. but next time i open the Master Cam it give me some error message with "Red X" saying "can not find entry point for mccore.dll during start up"

 

I have same problem on three other PC. after i install MU3.

 

Is any body else having the same problem. Is there any new MU for that bug

 

Window-XP, X4-MU3, Inventor 2010

[Sandybar]

When opening Inventor put your X4 disk in and Inventor will fix itself. It seems whem loading MU3 MasterCam replaces a .DLL file that Inventor used/needs. Inventor will then take the needed file off your disk and will run fine.