Mpfanuc question

[gms1]

I want to preload the next tool after the spindle direction callout

(3/8 FLAT ENDMILL TOOL - 4 DIA. OFF. - 54)

T4M6

G0G90G54X-50.1125Y-2.42S1000M3 < >----here

How can I add this so that it works for each tool?

Using MasterCam 8

and basic fanuc.pst from the addons zip from this page

Thanx

Greg

[Trevor Bailey]

V8 post:

pcan1, pbld, n, *sgcode, *sgabsinc, pwcs, pfxout, pfyout, pcout, *speed, *spindle, pgear, strcantext, *next_tool, e

*next_tool is what you have to add.

This is the line in your post you need to look for. It is in the psof & ptlchg sections.

V7 post, you will add the same info on the same line. If it still does not output, make sure "stagetool = one".

Trevor

[This message has been edited by Trevor (edited 12-14-2000).]

[gms1]

Thank you Trevor worked like a Charm