AXYZ CNC Router Post Processor

[Sam Mason]

Has anyone had a problem finding a post processor that would run an AXYZ CNC Router from a Mastercam file? Should I just use a generic post or should I consider trashing their Toolpath software and hooking up with the Mastercam Router package?

 

Thanks

[kccadcam]

Have you contacted your local Mastercam Dealer??

 

Always the best place to start.

[Allan]

The toolpath software will be needed to get the file to the machine. Last I heard AXYZ was working on a DNC set up where a PC could send the file serialy to the control. In any case the Mastercam router product would be a good choice over the toolpath software. IMHO

 

The code the control takes is very basic just use mpfan or mpez posts.

 

Allan

 

P.S. Welcome to the forum

 

[ 02-03-2003, 11:05 PM: Message edited by: Allan ]