post ?

[HEAVY METAL]

i have placed a post titled cim-x changer on the ftp site.i want to get it to post a clearance height between holes on the a g81 cycle. it is just doing this at the start of the first hole.

 

 

i any one wants to take a look and offer any suggestions thanks a bunch

 

heavy

[Roger Martin from CNC Software]

You have the INITHT & REFHT Z values available in the post.

Of course if you rapid the Z up, you will need to re-state the 'G8?' drill cycle at each hole location, since the 'G00' on the Z move will cancel the active canned cycle.

 

code:

---

%

/

/N0100 (MSG, Feb/19/03 11:09)

/N0102 (MSG, TOOL NO TOOL COMMENT)

/N0104 (MSG, T5 1/4 CENTERDRILL)

 

N0106 (MSG, T5 1/4 CENTERDRILL)

N0108G90

N0110G70

O0001T5M06

N0112 B0 H0

N0114G00H2X-32978Y43749

N0116S0350M03

N0118Z12500

N0120G81X-32978Y43749Z-6875R0F35

N0122G00Z12500

N0124X1495Y60070

N0126G81X1495Y60070Z-6875R0F35

N0128G00Z12500

N0130X-7337Y32874

N0132G81X-7337Y32874Z-6875R0F35

N0134G00Z12500

N0136M09

N0138M05

N0140M02

%

---

To get this code the only change made were in PDRILL_2 ->

 

code:

---

pdrill_2 # Canned Drill Cycle

n, "G00", *initht #Added (2/19/2003)

pdrillclc

n, pdrlxyrot, depthout, zdrl

pdrill #Added (2/19/2003)

---