Z constuction depth

[camguy]

Well, i finally moved up to V9 this week. I've been playing with it and so far so good. One question i have is whenever i create a toolpath my z constuction plane depth always reverts back to Z0 as soon as i finish selecting the geometry. This happens for all toolpaths ( contour, pocket, surface, etc )Is there a setting i can change somewhere, or is this tied in to the WCS. not a big problem really, but kind of annoying.

[BernieT]

Now I've just run into the same thing.

Using Ver 9.1, mill level 3.

 

Anybody find any reason for this or a way to stop it??

 

I found Z depth going back to 0 after every toolpath. I like to create toolpath boundries at Z 1.000 or .600 etc, if I decide to redo part of the boundry after a toolath, now it's at Z 0 again!!

 

??????????????????

[gcode]

The new service pak (V9.1 SP1) that came out Friday fixes this.

[BernieT]

Thanks gcode, I better get that fix!!