post tweek

[somename75]

I have been running X3 for some time now with a post that i have no complaints about untill now. I need to output arcs with z moves at the same time, hope I said that right..... all the switches ive played with in the machine def, have so far made no difference. When trying to do a helix, I get point to point no matter what i mess with, and would like to try arcs to see if it will run faster, as one of my machines has no look ahead. Any tips very much appreaciated. Thanks gents

[Guest]

First off, make sure your control def is set top output them

 

 

 

If it is, then check your tolerance to make sure it is not set too large

 

 

If the post is old enough, you "may" need to set it in the post

 

[somename75]

You sir are both a player and a pimp that worked like a charm, Thank you very much

[Guest]

Which one was it that you needed to adjust?

[somename75]

The control def, I had it halfway there, but apparently wasnt smart enough to get it all the way. I misunderstood what it was asking when it says arcs in all axis, I though it would make my poor haas think it was a horizontal Thanks again

[Hardmill]

please help a dummy tweak a post

 

 

I thought it was a Storkman post

 

 

 

 

 

PEACE