Is there an X5 setting for this?

[DavidSV]

For some reason when I am working on my toolpaths, if I have multiple tools, it always defaults to the 1st one. Something like this:

 

Chain the outside and use T1, chain one pocket with T2. Then go to chain another pocket and in the toolpath parameters page in the Tool tab, the 1st tool will be automatically selected instead of the previously used tool. Also, I had changed the speeds/feeds for the 2nd op, they will be changed back to the defaults. This never worked like this in the past versions. It would keep the last used tool and speeds/feeds to the next operation. Is there a setting for this that I need to change?

 

Thanks

[mwc815]

I get this too. It never did this before X5.

 

Mike

[TK-32™]

Same here.

[ChuckK]

You might want to try checking your settings, configuration, toolpath and turn "Lock Feedrates" off and see if that helps.

[DavidSV]

I tried that already. It doesn't change the tool selection part.

[mwc815]

You might want to try checking your settings, configuration, toolpath and turn "Lock Feedrates" off and see if that helps.

 

 

It isn't turned on.