X5 ... How do you add control points to a spline?

[Code_Breaker]

I am using the multiaxis tool path type ==> wire frame ==> Parallel to Multiple Curves ... The curve is a spline ... but when you back plot the tool path the tool axis will skips about two inches and travels in a straight line to the next point gouging the part .016 ....

 

Any other suggestions?

[gcode]

you need to add collision control to the toolpath

select the floor surface and set collision control to "retract along axis"

you can also use this to leave stock of a floor surface

[Code_Breaker]

you need to add collision control to the toolpath

select the floor surface and set collision control to "retract along axis"

you can also use this to leave stock of a floor surface

 

I did all that ... I ended up by saving toolpath, then drawing perpendicular line the the two axis lines, and broke the spline at those two point ... works fine ...

 

Thanks, I am still open to suggestion

[Guest SAIPEM]

I did all that ... I ended up by saving toolpath, then drawing perpendicular line the the two axis lines, and broke the spline at those two point ... works fine ...

 

Thanks, I am still open to suggestion

 

Get Rhino3D and then you can repoint and/or reprocess the spline.