Keeping my View

[allsys3]

I have my part in isometric view, when I try to open an operation to adjust cutting depth or any other variable the view keeps going back to top view. I am working on a piece with a multitude of holes all at different depths and wanted to pick the drilling depths from my model and it is very confusing when the view keeps switching. Is there a way for this not to happen. Thanks

[Guest]

Uncheck these 2 settings

 

 

[CJep]

Before you make any config settings start a new file in Mcam, with a saved part file open it will reset your file mapping.

 

In the configuration settings go to the page for CAD settings, there are two check boxes in the lower middle of the page "Update C&T plane when changing Gview" and "Reset Cplane to Top in Iso Gview".

[allsys3]

Much thanks guys (or gals if it fits).