Mastercam screen issues

[BenK]

What would cause my screen to look like this? I had Mastercam minimized and tried to open it by clicking on the tab at the bottom of the screen but it wouldn't open up. So I right clicked and closed it and when I launched Mastercam again my toolbars were pushed over to one side.

 

 

 

[NOTW Programmer]

A resolutions change, a graphics driver failure and refresh, going from 2 monitors to 1; the latter also tends to shift the icons on my desktop. At least that has been my experience.

[Colin Gilchrist]

To fix it, Right-Click in the Gray area where the toolbars are. From the menu, choose "Load Toolbar state" and pick your custom state, or choose one of the defaults (I use Design).

[Mr. Wizzard]

Mine did this when upgrading / installing newest version. Have you recently done this? If so, I had to redo all my customized toolbars and right click menus to get it to work properly. Also, check file paths. Somehow mine was choosing a default file path from an older version.

[BenK]

To fix it, Right-Click in the Gray area where the toolbars are. From the menu, choose "Load Toolbar state" and pick your custom state, or choose one of the defaults (I use Design).

 

This is what I did to fix it, I keep all my config files backed up as well. I am just trying to figure out why this keeps happening.

 

I upgraded once X5 MU1 came out but only started to have all the problems over the last two weeks. Maybe I should have my graphics card tested.

[Manuped68]

I have a part color that displays light grey but analyzes what ever color you change it to. It won't display proper color. Any suggestions?